Configuration Procedure; Overview; Enabling The Ports And Setting The Ip Addresses; Configuring The E-Mail Environment - Xerox 4112 System Administration Manual

Register a Mail Account
Configuring the E-mail
Environment

Configuration procedure

Overview

Enabling the ports and setting the IP addresses

X er o x 4 112 /4 1 27 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
In order to use e-mail on the machine, a mail account for the
machine needs to be registered.
Enable the port and configure the machine e-mail address,
TCP/IP environment, and e-mail server from the machine.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
This section describes the configuration procedure to use the e-
mail feature on the machine.
The following two steps are necessary to use the e-mail feature:
• Enabling the port and setting TCP/IP: Set the machine to be
able to use TCP/IP
• Configuring the e-mail feature: Set the e-mail function items
on the machine.
This section describes the configuration procedure to use TCP/IP
on the machine.
First enable the e-mail port, then set the IP address.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Enter the System Administrator Mode (Chapter 1 Entering the
1.
System Administrator Mode on page 1-15.)
Enable the ports that are used for the e-mail feature.
2.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select Send E-mail and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enabled and then select Save.
g. Select Recieve E-mail and then select Change Settings.
4 . E - ma i l
4-3