Ipp Configuration; Changing Ipp Settings At The Printer - Xerox WORKCENTRE 7428 System Administrator Manual

Network Management

IPP Configuration

The Internet Printing Protocol provides a convenient way to print over the Internet or Intranet using
the printer's IP address. To support this type of printing, make sure that Port 9100 is enabled at the
printer. Click Port Status in the Connectivity folder on the Properties Tab of CentreWare Internet
Services and make sure that the check box on the Port 9100 line is checked. The Internet Printing
Protocol must also be enabled at the printer, and the Internet Print Service must be available and
installed on the individual computer's version of Windows. IPP support is already built into Windows
operating systems. For other desktop operating systems it is available as a download from Microsoft at
www.microsoft.com. The final step is to install the IPP print driver. For more information, see
Driver Installation on page 13.

Changing IPP Settings at the Printer

1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator's Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. Press the IPP selection line on the Port Settings menu.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the IPP selection menu displays, note that you have two selections available on numbered
horizontal lines. The first selection is Port Status. The second is IPP – Added Port Number. The Close
button in the upper right corner of the screen returns you to the Port Settings menu. After pressing
the horizontal line selection, to access available settings press the Change Settings button in the
lower right corner of the touch screen.
Port Status (IPP Enablement)
1. On the IPP selection menu, press Port Status.
2. Press the Change Settings button.
3. On the IPP Port Status screen, note which of the two buttons is highlighted as the current setting
for IPP Enablement. The available settings are Enabled or Disabled. To print with IPP, this setting
must be Enabled.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
54 WorkCentre 7425/7428/7435
System Administrator Guide
Print