Switching Off The Power; While Printing - Xerox 4112 System Administration Manual

X er o x 4 112 /4 1 27 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e

Switching Off the Power

Check the following points when switching off the machine:
• When the lpd (Spool) is set to Memory.
All print data spooled within the machine memory, including
the data which is being printed is erased. The print data will
not be found when the machine is powered on again.
However, if the power was switched off immediately after a
computer instructed a print job, the job may remain on the
computer. In this case, the stored data on the computer will be
printed out in order before any later instructions when the
machine is powered back on.
• When the lpd (Spool) is set to Hard Disk.
All print data spooled in the machine hard disk, including the
data which is being printed is preserved. In this case, the
stored data on the machine hard disk will be printed out in
order before any later instructions when the machine is
powered back on.
• When the lpd (Spool) is set to Off.
All print data spooled in the machine receiving buffer, including
the data which is being printed is erased. The print data will
not be found when the machine is powered on again.
However, if the power was switched off immediately after a
computer instructed a print job, the job may remain on the
computer. In this case, the stored data on the computer will be
printed out in order before any later instructions when the
machine is powered back on.

While Printing

• When the lpt (Spool) is set to either Hard Disk or Memory.
If the transmitted print data size exceeded the available
amount of either hard disk or memory, the print data will not be
received.
NOTE: When the print data has exceeded the receivable size,
some computers may immediately re-transmit the print data.
When this occurs, the computer appears to be halted. Deal with
this problem by canceling the print data transmission from the
computer.
• When the lpd (Spool) is set to Off.
While the machine is receiving a print request from a
computer, the machine cannot accept any print requests from
other computers.
• When the IP address of a computer or a computer name is
changed.
9 . Tr ou b le s h oo ti n g
9-13