Other Problems - Minolta MAGICOLOR 3100 User Manual

Other Problems

Symptom
Printer power
is not on.
"Printer
is not
responding" is
displayed in
the print
monitor.
Printer takes
too long to
start when you
are replacing
the imaging
unit.
82
Cause
The power cord is
not correctly
plugged into the
outlet.
The power switch
has not been
pressed.
The power switch is
not correctly turned
on (I position).
Something is wrong
with the outlet you
are using for the
printer.
The printer is
connected to an
outlet with a voltage
or frequency that
does not match
the printer
specifications.
The printer is in
energy-saving
mode.
The printer takes
approximately 6
minutes to warm up
when a new
imaging unit is
installed.
Solution
Set the power switch off (O position), then
remove the power cord from the outlet
and plug it back in, then set it back to the
on (I) position.
Set the power switch to the on (I)
position.
Set the power switch to the off (O)
position, then set it back to the on (I)
position.
Plug another electrical appliance into the
outlet and see whether it operates
properly.
Use a power source with the
specifications listed in appendix A of the
User's Guide .
It takes a little time for printing to start if
the printer is in energy-saving mode. You
can change the number of minutes before
the printer switches to power-saving
mode in the Administration/Engine/
Energy Saver menu. If you do not want to
use this mode, disable it in the
Administration/Engine/Energy Saver
menu.
Wait. No action needed.
Solving Problems