Minolta MAGICOLOR 3100 User Manual page 65

Make sure any parts removed during cleaning are replaced before you plug in
the printer.
Use
Exterior
A soft dry cloth to clean the
control panel.
A soft damp cloth to clean the
outside of the printer.
Mild neutral detergent to clean the
outside of the printer if stains
remain. (Always test any cleaning
solution on a small area of your
printer to check the solution's
performance).
Interior
A soft dry cloth or cotton swab to
clean the density sensor.
WARNING!
Turn off the printer, unplug the power cord, and disconnect all interface
cables before cleaning.
ACHTUNG! Ziehen Sie den Netzstecker aus der Steckdose bevor Sie
den Drucker reinigen.
„
Be careful when cleaning the inside or removing paper jams, as the fuser
unit and other internal parts may become very hot. Either clean the
density sensor before use, or allow time after unplugging the printer
to allow the fuser unit to cool down.
Attention
The fuser unit is hot. When the front cover is opened, the
fuser unit temperature drops gradually (one hour wait time).
Cleaning
Avoid
Sharp or rough implements (such as wire
or plastic cleaning pads); any liquid.
Sharp or rough implements (such as wire
or plastic cleaning pads).
Abrasive or corrosive solutions that
contain solvents (such as alcohol or
benzine); aerosol or pump-sprayed
cleaners.
Vacuuming.
Pulling media too hard and tearing it.
Sharp implements (such as tweezers)
59