Minolta magicolor 3100 Maintenance Manual
Minolta magicolor 3100 Maintenance Manual

Minolta magicolor 3100 Maintenance Manual

Hide thumbs Also See for magicolor 3100:

Advertisement

magicolor 3100
®
Maintenance
Guide
1800657-001D

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the magicolor 3100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Minolta magicolor 3100

  • Page 1 3100 ® Maintenance Guide 1800657-001D...
  • Page 2 The following are registered trademarks of MINOLTA-QMS, Inc.: QMS, the MINOLTA-QMS logo, Crown, and magicolor. Minolta is a trademark of Minolta Co., Ltd. Other product names mentioned in this guide may also be trademarks or registered trademarks of their respective owners.
  • Page 3: Media Specifications

    Media Specifications All media is fed short edge first and is output to the 250-sheet output tray on top of the printer. The imageable (printable) area for all media sizes is the page size minus 0.157" (4 mm) from all edges. Media Inches Millimeters...
  • Page 4: Loading Media

    Loading Media...
  • Page 5 5 7 6...
  • Page 6: Clearing Media Jams

    Clearing Media Jams After clearing a media jam, open and then close the front cover to reset the printer. 5 5 5 5 4 4 4 4...
  • Page 7 5 5 5 5 4 4 4 4 5 5 5 5 4 4 4 4...
  • Page 8: Maintenance Schedule

    Maintenance Schedule Attention Consumable life is expressed in simplex letter/A4 pages at normal 5% coverage in continuous printing. A duplex page is equivalent to two simplex pages. The stated life expectancy of each consumable is based on printing under specific operating conditions, such as ratio of color to monochrome, and media type and size.
  • Page 9 Consumables Life Expectancies Fuser Unit and Approximately 100,000 simplex pages Media Feed Roller(s) Imaging Unit* Imaging Unit* Number of Maximum Percent Toner Maximum Pages per Job Simplex Coverage (Four- Simplex Pages Page Average) Pages 12,500 35%–40% 15,000 21,000 30%–35% 17,000 26,000 25%–30% 20,000...
  • Page 10: Error Messages

    OPEN The printer has detected a To resume printing and to prevent INVALID nongenuine MINOLTA- permanent damage to your MINOLTA- IMAGING UNIT QMS imaging unit. QMS printer, replace the imaging unit with a genuine MINOLTA-QMS imaging unit. If you are using a genuine MINOLTA-QMS imaging unit and still receive this error, contact Support.
  • Page 11: Media Jam

    Error Message Problem Solution Duplex jams occur in the Locate and remove the jam. Open and MEDIA JAM duplex area. close the front door to reset the printer. < X > Feed jams occur between the media tray and the print engine.
  • Page 12: Replacing A Toner Cartridge

    Replacing a Toner Cartridge...
  • Page 14: Replacing The Imaging Unit

    Replacing the Imaging Unit...
  • Page 16 Replacing the Fuser Unit and Media Feed Roller(s) Fuser Unit 5 5 5 5 4 4 4 4...
  • Page 17 5 5 5 5 4 4 4 4 5 5 5 5...
  • Page 18 Media Feed Roller(s) 6 6 6 6...
  • Page 19: Replacing The Transfer Unit

    Replacing the Transfer Unit...
  • Page 20: Cleaning Schedule

    ADC SENSOR DUSTINESS WARNING appears in the message window. Note: We recommend that you do not clean elsewhere inside the printer. If necessary, refer to the Service & Support Guide for a MINOLTA-QMS-authorized service provider near you. Cleaning Guidelines Exterior—Use Exterior—Avoid...
  • Page 21 Cleaning the Printer Exterior Cleaning the Density Sensor 4 4 4 4 5 5 5 5 5 5 5 5 4 4 4 4...

Table of Contents