Minolta MAGICOLOR 3100 User Manual page 86

Symptom Cause
Media is The wrong media tray
jamming. is used.
The media is not
correctly positioned in
the tray.
The number of
sheets in the tray
exceeds the
maximum allowed.
The width regulation
guides are not
correctly adjusted to
the media size.
Warped or wrinkled
media is loaded in
the tray.
The media is moist
from humidity.
Unsupported media
(wrong size,
thickness, coating,
type, etc.) is being
used.
The recommended
transparency (OHP)
or label paper is
facing the wrong way
in the tray.
Coated transparency
media has been
used.
Multiple sheets of
transparency (OHP)
media are collecting
static electricity in
the tray.
80
Solution
Envelopes, labels, postcards, and Thick 3
can be printed only from the multipurpose
tray.
Remove the jammed media and reposition
the media properly in the tray.
Remove the excess media and reload the
correct number of sheets in the tray.
Adjust the regulation guides in the tray to
match the size of the media.
Remove the warped or wrinkled media and
replace it with new media.
Remove the moist media and replace it with
new, dry media.
Use media that is approved for your printer.
Refer to "What are the media types
supported?" on page 33.
Load the transparencies or labels according
to the manufacturer's instructions.
Use uncoated transparency media that is
approved for your printer.
Remove the OHP media and load it in the
tray one sheet at a time. Do not fan large
quantities of transparencies before loading
them.
Solving Problems