Minolta MAGICOLOR 3100 User Manual page 139

1
Turn off the printer, and then
disconnect the power cord and
all interface cables from the
printer.
2
Loosen two screws (one on
each end of the interface panel)
and, using the tab on the lower
side of the panel, pull the
controller board from
the printer.
3
Position the controller board on
a flat surface so the controller board lies flat and the interface panel is
facing you.
4
Attach the internal IDE
hard disk drive to the hard
disk bracket.
Attach the internal IDE
hard disk drive to the
bracket with the grooved-
end of the bracket facing
the ribbon cable.
The screw holes in the
bottom of the hard disk
should match up with the
holes on the hard disk
bracket.
Fasten the hard disk to the bracket with the screws provided.
5
Position the hard disk so that the four support posts face the controller
board, the colored stripe on the ribbon cable faces away from you, and
the connector is down.
6
Insert ribbon cable connector pin 1 (the colored stripe side of the cable) in
hard disk connector pin 1.
Attention
Make sure that the ribbon cable connector and the controller board
connector pins are properly aligned. Damage to the controller board
could result if the pins are misaligned.
Internal IDE Hard Disk Drive
133