Time-Of-Day Clock - Minolta MAGICOLOR 3100 User Manual

7
Press down gently but firmly on the cable connector until it is fully seated.
Attention
Do not push or pull with the ribbon cable. Use the cable connector.
8
Align the support posts with the holes on the controller board, and then
press down to secure the hard disk to the controller board.
So that you don't stress the board, press one corner at a time to secure
the hard disk to the controller board.
9
Reinstall the controller board into the printer.
Gently slide the controller board into the printer's tracks until it is fully
seated, and then tighten the two screws.
10
Reconnect all interface cables.
11
Reconnect the power cord and turn on the printer.
5 "
In compliance with UL guidelines, "The appliance inlet is consid-
ered to be the main disconnect device."
When you print a startup page, verify that the hard disk is listed.

Time-of-Day Clock

The time-of-day clock provides time and date information on the startup page
and in the accounting data.
Installation
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 109. In addition,
always handle circuit boards by the edges only.
134 Time-of-Day Clock