Minolta MAGICOLOR 3100 User Manual page 137

4
Attach the ribbon
cable to its connector
on the SCSI inter-
face card.
a
Position the SCSI
interface card so
that its ribbon
cable connector
aligns with the
SCSI connector
on the controller
board.
b
Gently press the
ribbon cable connector down until it's fully seated.
Attention
Make sure that the connectors on the ribbon cable and the controller
board are properly aligned. Damage to the controller board could
result if the pins are misaligned.
c
Insert the SCSI interface card connector into its opening in the inter-
face panel.
d
Secure the SCSI interface card to the interface panel with the two
larger screws in the kit.
5
Reinstall the controller board.
Gently slide the controller board into the printer's tracks until it's fully
seated, and then tighten the controller board's two screws.
6
Reconnect all interface cables.
7
Reconnect the power cord and turn on the printer.
5 "
In compliance with UL guidelines, "The appliance inlet is consid-
ered to be the main disconnect device."
8
Print a startup page.
Check that the startup page lists the interface (SCSI) just installed under
"Options."
Using a SCSI Interface
5 "
Installing a SCSI interface allows the attachment of external SCSI
storage devices, such as hard drives, and Jaz and Zip drives. Install-
ing the SCSI interface kit will not allow you to print via SCSI.
SCSI Interface
131