Minolta MAGICOLOR 3100 User Manual page 142

3
Attach the time-of-
day clock to the
controller board.
Attention
Make sure that the pins on the time-of-day clock are properly aligned
with those in the receiving socket on the controller board. Damage
to the time-of-day clock and/or controller board could result if the
pins are misaligned.
a
Locate the time-of-day clock socket on the controller board and the pin
1 notch or printed label.
b
Locate the pin 1 indicator mark on the top of the time-of-day clock.
This mark may be a notch or a slight depression on one end of the
clock.
c
Align this indicator mark with the pin 1 notch or printed label on the
controller board.
d
Gently press down on the time-of-day clock until it's firmly seated.
4
Reinstall the controller board.
Gently slide the controller board into the printer's tracks until it is fully
seated, and then tighten the screws.
5
Reconnect all interface cables.
6
Reconnect the power cord and turn on the printer.
5 "
In compliance with UL guidelines, "The appliance inlet is
considered to be the main disconnect device."
The presence of the clock will be automatically sensed.
136
Pin 1 indicator
Pin 1 notch/label
Time-of-Day Clock