Minolta MAGICOLOR 3100 User Manual page 136

for fonts, emulations, and other files; increase the number of pages that can
be collated; and provide a secondary storage area for spooled data, while
providing virtual memory capabilities.
In order to back up the hard disk contents to a Jaz drive, you must increase
the Disk Cache manually to at least 1 MB. For more information about
increasing the memory in the Disk Cache, refer to the CrownBooks .
What's in the Kit?
An optional SCSI interface kit includes the following:
„
SCSI interface card
„
SCSI interface card ribbon cable
„
Connector face plate
„
Two larger screws, two smaller screws
Installation
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 109. In addition,
always handle circuit boards by the edges only.
1
Turn off the printer,
and then disconnect
the power cord and all
interface cables from
the printer.
2
Loosen two screws
(one on each end of
the interface panel)
and, using the tab on
the lower side of the
panel, pull the
controller board
from the printer.
3
Remove the two screws holding the metal plate over the SCSI interface
opening.
You can dispose of the metal plate and screws according to local
regulations.
130 SCSI Interface