Other Problems - Minolta magicolor 7300 User Manual

Other Problems

If multiple toner cartridges, print units, or consumables are empty or worn out
at the same time, each message will flash for two seconds. Perform the
necessary operation for each message displayed in the message window.
Symptom
Printer
power is
not on.
"Printer is
not
responding"
is displayed
in the Print
Monitor.
190
Cause
The power cord is not
correctly plugged into
the outlet.
Something is wrong
with the printer outlet.
that the printer is
plugged into.
The power switch has
not been pressed.
The power switch is
not correctly set to
the on (I) position.
The printer is
connected to an
outlet with a voltage
or frequency that
does not match the
printer specifications.
The printer is in
Energy Saver mode
to reduce power
consumption during
periods of inactivity.
When a print job is
received, the printer
returns to normal
power within 90
seconds.
Solution
Turn the power switch off (O position),
then remove the power cord from the
outlet and plug it back in.
If the outlet is connected to a switch,
turn on the switch.
Plug another electrical appliance into
the outlet and see whether it operates
properly.
Set the power switch to the on (I)
position.
Set the power switch to the off (O)
position, and then set it back to the on
(I) position.
Use a power source with the
specifications listed in appendix A,
"Technical Specifications," on page
211.
It takes a little time for printing to restart
after the printer has entered
energy-saving mode. You can change
the number of minutes before the
printer switches to energy-saving mode
from the Sys Default/Energy
Saver menu.
Solving Problems