Minolta MAGICOLOR 3100 User Manual page 134

What's in the Kit?
An optional interface kit includes the following:
„
An interface card
„
Interface documentation (in hardcopy and/or on CD-ROM)
The kit may also include additional parts not required for network interface
installation on this printer.
Installation
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 109. In addition,
always handle circuit boards by the edges only.
1
Turn off the printer,
and then disconnect
the power cord and
all interface cables
from the printer.
2
Loosen two screws
(one on each end of
the interface panel)
and, using the tab on
the lower side of the
panel, pull the
controller board
from the printer.
3
Remove the two
screws holding the metal
plate over the optional inter-
face opening.
The optional interface open-
ing is located next to the
"Parallel" port. Save the two
screws. (You'll use them
when you install the optional
interface card.) You can dis-
pose of the plate according
to local regulations.
4
Attach the interface card to the controller board.
128 Interfaces and Daughterboards