Table of Contents
Advertisement
This message...
OUTPUT BIN FULL
PRINTING STATUS
PUT < SIZE > PAPER
IN < ANY > BIN
PUT < TYPE MEDIA >
IN < INPUT > BIN
PUT < X > IN INPUT
< Y >
REPLACE < X >
RESETTING
ACCOUNTING
102
means...
The media has
exceeded the limit
(such as over 250
sheets of 20 lb [75 g/
m
] bond) in the
2
output bin.
A status page is
printing.
The Operator
Control/Chain
Inputbins is set to Off
and the displayed
tray is empty. Refill it
with the specified size
media. < SIZE> is the
media size detected
by the engine, and
< ANY> is the empty
tray.
Operator Control/
Chain Inputbins is set
to On and a chained
tray is empty.
The < X > specified
media is not in the
input tray < Y >.
The specified item
< X > needs to be
replaced, such as the
fuser unit, the transfer
unit, and the imaging
unit.
The reset accounting
operation is in
process.
Status, Error, and Service Messages
do this...
Remove the media from
the output bin.
Wait until after the
status page prints and
the message clears.
Refill the tray with the
specified size media.
Refill the tray with the
specified type media.
Refill the tray with the
specified type media.
Replace the specified
item.
Wait. No other action
needed.
Advertisement
Chapters
Table of Contents
Troubleshooting
