Diskette Drive Cabling; Pc Card Adapter Cabling - NEC POWERMATE VT 300 Manual

4. If you are installing a CD-ROM drive and your system
has speakers, connect the audio cable to the CD In
connector on the system board or an audio board (see the
instructions that come with the drive).

Diskette Drive Cabling

Cable a diskette drive as follows.
1. Connect the diskette drive signal cable connector to the
signal connector on the diskette drive.
2. Locate an available power connector coming from the
power supply.
3. Connect the power cable to the power connector on the
device.

PC Card Adapter Cabling

Cable a PC card adapter as follows.
1. Connect the connectors at one end of the card adapter
cable set to the PC adapter board. The connectors are
keyed to fit only one way.
The PC ISA adapter board installs in the ISA expansion
slot. See "Installing an Expansion Board" if the board
must be installed first.
2. Connect the connectors at the other end of the cable set to
the connectors at the rear of the PC card adapter.
The PC card adapter installs in a 5 1/4-inch bay. If the
adapter must be installed first, see "Installing a 5 1/4-inch
Device" later in this chapter.
Installing Options 4-43