Icom IC-7760 Advanced Manual page 89

8
SCANS
Programmed scan and Fine Programmed scan
Scan edge
P1 or P2
Lower
frequency
Repeatedly scans between two Scan Edge
frequencies.
The edge frequencies are preset in P1 and P2 as the
default. (P1: 0.500000 MHz / P2: 29.999999 MHz)
L To change the P1 and P2 Scan Edge Memory channels,
see page 7-2 for details.
L If the same frequencies are entered into P1 and P2, the
Programmed scan does not start.
L The Fine Programmed scan is most effective in the
SSB, CW, and RTTY modes.
Scan edge
P2 or P1
Scan
Jump
Higher
frequency
D Programmed scan operation
1. Select the VFO mode in the Main band.
2. Select the operating mode and tuning step.
(Example: USB, 1 kHz)
3. Display the SCAN screen.
» SCAN
MENU
4. Touch [PROG] to start the Programmed scan.
L When a signal is detected, the scan pauses
according to the "SCAN Resume" setting, and then
resumes.
L You can change the operating mode and the tuning
step while scanning.
L To cancel the scan, touch [PROG].
5. To switch to the Fine Programmed scan, touch
[FINE].
• The tuning step changes to 50 Hz steps.
L When a signal is detected, the tuning step changes to
10 Hz steps.
L To return to the Programmed scan, touch [FINE]
again.
6. To close the SCAN screen, push
8-4
Blinks
Frequency before scan
Blinks
EXIT
.