Icom IC-7760 Advanced Manual page 40

2
ADVANCED OPERATIONS
FM repeater operation
A repeater receives your transceiver's signals and
simultaneously retransmits them on a different
frequency to provide a greater communication range.
When using a repeater, the transmit frequency shifts
from the receive frequency by an offset amount. You
can access a repeater using the split function.
1. Select the VFO mode.
2. Set the operating frequency in the FM mode.
(Example: 29.650.00 MHz)
3. Hold down for 1 second.
SPLIT
• Turns ON the Quick Split function.
• Turns the Tone function ON and "TONE" is displayed.
• The TX indicator and the repeater's receive
frequency are displayed on the Sub band.
L You can set the frequency offset for the HF band.
» SET > Function > SPLIT >
MENU
FM SPLIT Offset (HF)
L You can set the frequency offset for the 50 MHz
band.
» SET > Function > SPLIT >
MENU
FM SPLIT Offset (50M)
Repeater Tone ON
Split function ON
Repeater's receive
frequency
D Checking the repeater input signal
You can check whether or not you can directly receive
another station's transmit signal, by listening to the
repeater input frequency.
L While listening, the TX/RX indicator lights green, and
then the Noise Reduction and Notch Filter settings are
canceled.
z While receiving, hold down
repeater input frequency.
Quick Split function ON
While holding
down
XFC
Another station's transmit frequency
2-30
to listen to the
XFC
XFC
Release
.
The offset between transmit and receive
.
XFC