Icom IC-7760 Advanced Manual page 115

13
UPDATING THE FIRMWARE
Updating the firmware
CAUTION: NEVER turn OFF the transceiver or
disconnect the RF deck and controller while updating
the firmware. If you turn OFF the transceiver, and a
power failure occurs, or disconnect the RF deck and
controller while updating, the transceiver firmware
may be damaged, and you may have to send the
transceiver back to the nearest Icom distributor for
repair. This type of repair is out of warranty, even if
the transceiver warranty period is still valid.
1. Copy the downloaded firmware data into the
"IC-7760" folder on an SD card or a USB flash
drive. (Example: SD card)
2. Insert the SD card or USB flash drive into the
transceiver.
3. Display the SD CARD or USB FLASH DRIVE
screen.
» SET > SD Card
MENU
» SET > USB Flash Drive
MENU
4. Touch "Firmware Update."
Copy
13-4
5. Touch [▼] to scroll the screen and read all the
precautions.
6. After you read and agree with all the precautions,
touch [YES].
• The confirmation dialog is displayed.
When you touch [YES], the backup file is made on
the SD card, and then the Firmware selection screen
is displayed.
7. Touch the Firmware (Example: 7760_*).
* Represents the release number.
• The final confirmation screen is displayed.
L Carefully read all the displayed precautions.
8. After you read and agree with all the precautions,
touch [YES] for 1 second.
• The updating starts.
9. When the update is completed, "Firmware updating
has completed." is displayed in the dialog.
• The transceiver will automatically restart.
L After the updating finishes, the operating screen is
displayed.
TIP: If "Firmware updating has stopped because the
RF deck connection was lost." is displayed, restart
the transceiver, and then retry updating the firmware.
Touch for 1 second