Icom IC-7760 Advanced Manual page 12

2
ADVANCED OPERATIONS
Band Edge Beep
D Band Edge Beep
You will hear a Band Edge Beep and
dotted border) will be displayed when you tune into or
out of an amateur band's frequency range.
L You can change the Band Edge Beep settings in the
following menu.
» SET > Function > Band Edge Beep
MENU
L If "Beep Level" is set to "0%," no beep sounds.
» SET > Function > Beep Level
MENU
D Entering a Band Edge
When "ON (User)" or "ON (User) & TX Limit" is
selected on the "Band Edge Beep" screen, you can
enter a total of 30 band edge frequency pairs.
L Information
• Initially, all Ham band frequencies are entered. Therefore,
you must first edit or delete them, and then insert a new
line to enter a new band edge.
• You cannot enter an overlapping frequency, or a
frequency that is out of the preset Ham band frequencies.
• The default setting may differ, depending on the
transceiver version.
• Band edges are entered from the lower frequency first.
1. Open the "Band Edge Beep" screen.
» SET > Function > Band Edge Beep
MENU
2. Touch "ON (User)" or "ON (User) & TX Limit."
L If you set "ON (User) & TX Limit," you can limit
transmission to within the entered frequency range.
3. Touch "User Band Edge."
• Opens the "User Band Edge" screen.
Editing a Band Edge
(with a
You can edit a band edge entered as a default, or
change the band edge frequencies.
1. Open the "User Band Edge" screen.
2. Touch the band edge you want to edit.
3. Edit the lower band edge frequency, then touch
4. Edit the upper band edge frequency, then touch
TIP: You can also edit the frequency by rotating
MAIN DIAL
2-2
(Example: 6: 14.000.000 – 14.350.000 MHz)
[ENT]. (Example: 14.1)
Entry example: [•] [1] [ENT]
[ENT]. (Example: 14.25)
Entry example: [•] [2] [5] [ENT]
• The edited band edge is saved, and returns to the
previous screen.
or .
MULTI