Ricoh Aficio 2232C User Manual page 874

Sending Scan File by Scan to Folder
❒ [Connection Test] can not be
pressed right after [Cancel]
was pressed during the con-
nection test.
❒ Though the connection test is
s u c c e e d e d , t h e m a c h i n e
sometimes fails in the file
transfer, when the shared
folder lacks writing authori-
ty or when there is no space
in the hard disk.
M To enter more destinations, re-
peat steps A A A A to L L L L .
Note
❒ To deselect a destination,
press [U U U U Prev.] or [T T T T Next] to
5
display the destination in the
destination field, and then
press the { { { { Clear/Stop} } } } key.
N Press [OK].
Specifying a folder in the FTP
server
A Press [Enter Destination].
B Press [FTP].
A confirmation message for
changing the protocol appears.
C Press [Yes].
D Press [Manual Input] on the right
side of the server name field.
The soft keyboard is displayed
for entering the server name.
64
E Enter a server name.
Note
❒ An IP address can be also en-
tered.
F Press [OK].
G Press [Manual Input] on the right
side of the path field.
The soft keyboard is displayed
for entering the path for the
folder.
H Enter the path for the folder.
Note
❒ This is a pass to send to the
sub-folder "lib" in the folder
"user". user\lib
Reference
For information about how
to enter characters, see Gener-
al Settings Guide.
I Press [OK].
J If entering a user name to log
on is required, press [Manual In-
put] on the right side of the user
name.
The soft keyboard is displayed
for entering the user name.
K Enter the user name.
L Press [OK].
M If entering a password to log
on is required, press [Manual In-
put] for password.
The soft keyboard is displayed
for entering a password.
N Enter a password.
O Press [OK].
P To change the port number
which is set in the initial scan
setting, press [Change] on the
right side of the Port No. field.
Enter a port number using the
number keys, and then press
[#].