Printing With A Mac Os; Changing To Ethertalk - Ricoh Aficio 2232C User Manual

Printing with a Mac OS

This describes how to configure a
Mac OS computer to use EtherTalk.
Actual procedures may vary depend-
ing on the version of the Mac OS. The
following procedures describe how to
configure Mac OS 9.1 and Mac OS X
v10.1. If you are using other version
than Mac OS 9.1 and Mac OS X v10.1,
see the manual that comes with Mac
OS for more information.
Basic Procedure
Change to EtherTalk
Configure the printer
Change the printer name
Change the zone
Note
❒ Mac OS 8.6 and later versions are
supported (except for Mac OS X
v10.0.x).
❒ To print from a Mac OS, PostScript
3 option is required.

Changing to EtherTalk

Follow the procedure below to con-
figure a Mac OS computer to use
EtherTalk.
Reference
For more information about in-
stalling the software required for
EtherTalk, see the Mac OS manu-
als.
Mac OS
A A A A
Open [Control Panel], and then
double-click the AppleTalk icon.
B B B B
On the [Connect via] pop-up menu,
click [Ethernet].
C C C C
If you change zones, select a name
on the [Current zone] pop-up menu.
D D D D
Close the [AppleTalk] control pan-
el.
E E E E
Restart the Mac OS.
Mac OS X
Note
❒ You need an administrator name
and a password (phrase). For more
information, consult your admin-
istrator.
A A A A
Open [System Preferences], and
then click the Network icon.
B B B B
From the [show] menu, select
[Built-in Ethernet].
C C C C
Click the [AppleTalk] tab.
D D D D
If you change zones, select a name
on the [AppleTalk Zone:] pop-up
menu.
E E E E
When the setting is complete,
click [Apply Now].
Printing with a Mac OS
5
63