Ricoh Aficio 2232C User Manual page 1045

DNS
Use the "dns" command to configure
or display DNS (Domain Name Sys-
tem) settings.
❖ ❖ ❖ ❖ View setting
The following command displays
current DNS settings:
msh> dns
❖ ❖ ❖ ❖ Using the DNS server obtained from
the DHCP server
The following command ena-
bles/disables use the DNS server
obtained from the DHCP server:
msh> dns dhcp {valid |
invalid}
• If you use the DNS server ob-
tained from the DHCP server,
select "valid". If not, select
"invalid".
If you set "valid", the DNS serv-
er from the DHCP server is pri-
oritized.
❖ ❖ ❖ ❖ DNS server configuration
The following command ena-
bles/disables use of the DNS serv-
er address:
msh> dns number server
server address
The following is a sample configu-
ration using an IP address of
192.168.15.16 on DNS 1 server:
msh> dns 1 server
192.168.15.16
• You can register up to three
DNS server numbers.
• You cannot use "255.255.255.255"
as the DNS server address.
Remote Maintenance by telnet
Domain name
Use the "domainname" command to
display or configure domain name
settings.
You can configure the Ethernet inter-
face, IEEE 1394 interface, or IEEE
802.11b interface.
❖ ❖ ❖ ❖ View setting
The following command displays
the current domain name:
msh> domainname
❖ ❖ ❖ ❖ Interface domain configuration
The following command displays
or sets the Ethernet interface do-
main name, IEEE 1394 interface, or
IEEE 802.11b interface.
msh > domainname
interface_name domainname
The following is a sample configu-
ration using a domain name on the
Ethernet interface:
msh> domainname ether
Interface
ether
*1
ip1394
*2
wlan
*1
Available when the optional IEEE
1394 interface board is installed.
*2
Available when the optional IEEE
802.11b interface unit is installed.
Note
❒ A domain name can consist of
up to 63 alphanumeric charac-
ters.
Interface that can
be set
Ethernet interface
IEEE 1394 interface
IEEE 802.11b inter-
face
111
9