Commands List - Ricoh Aficio 2232C User Manual

Appendix

Commands List

Use the "help" command to display
remote maintenance use.
Note
❒ Enter "help" to display a list of
commands that can be used.
msh> help
❒ Enter "help command_name" to
display information about the syn-
tax of that command.
msh> help command_name
TCP/IP address
Use the "ifconfig" command to con-
figure the Ethernet interface, the IEEE
1394 interface/IEEE 802.11b, and the
TCP/IP (IP address, subnet mask,
broadcast address, default gateway
address) for the machine.
❖ ❖ ❖ ❖ Reference
msh> ifconfig
❖ ❖ ❖ ❖ Configuration
msh> ifconfig interface_name
parameter address
9
Interface name Interface to be configured
ether
*2
ip1394
*3
wlan
*1
If you did not enter an interface
name, it will automatically be set to
the Ethernet interface.
*2
Available when the optional IEEE
1394 interface board is installed.
*3
You can specify an interface when
i n s t a l l i n g t h e o p t i o n a l I E E E
802.11b interface unit.
Parameter
(no parameter) IP address
netmask
broadcast
98
*1
Ethernet interface
IEEE 1394 interface
IEEE 802.11b interface
Meaning
subnet mask
broadcast address
❖ ❖ ❖ ❖ Changing the Interface
You can specify either Ethernet in-
terface or IEEE 802.11b interface
when using the optional IEEE
802.11b interface unit.
msh> ifconfig interface up
Note
❒ You cannot specify the optional
I E E E 1 3 9 4 i n t e r f a c e b o a r d
(ip1394).
The following is a sample configura-
t i o n , u s i n g a n I P a d d r e s s o f
192.168.15.16 on an Ethernet inter-
face:
msh> ifconfig ether
192.168.15.16
The following is a sample configura-
t i o n , u s i n g a s u b n e t m a s k o f
255.255.255.0 on an Ethernet inter-
face:
msh> ifconfig ether netmask
255.255.255.0
Note
❒ This affects the configuration of
the network interface board on the
IP address used.
❒ The TCP/IP setting is the same as
that of the Ethernet interface and
IEEE 802.11b interface.
❒ To enter an address using hexadec-
imal, prefix it with "0x".