Ricoh Aficio 2232C User Manual page 1035

Printer status
The following command can be used
to get information about the current
printer status:
msh> command
Command Information that is dis-
played
status Status of printer.
Information about print
jobs.
info Information about the
paper tray, output tray,
printer language of
printer.
prnlog [ID] Lists the last 50 print jobs.
Note
❒ For more information about print
jobs is displayed when the ID
number is added after the prnlog
command.
Reference
For more information about the
meaning of the data returned using
these commands, see p.120 "Under-
standing Displayed Information".
Network interface board configuration
settings information
Use the "show" command to display
the network interface board configu-
ration settings.
msh> show [-p]
Note
❒ Add "-p" (as above) to have the in-
formation displayed one screen at
a time.
Reference
For more information about the
meaning of the data returned using
this command, see p.125 "Configur-
ing the Network Interface Board".
Remote Maintenance by telnet
System log information
Use the "syslog" command to display
information stored in the system log.
msh> syslog
Reference
For more information about the
displayed information, see p.130
"System Log Information".
SNMP
Use the "snmp" command to display
and edit SNMP configuration settings
such as the community name.
Limitation
❒ The optional IEEE 1394 interface
board supports TCP/IP only.
Note
❒ You can configure one of ten
SNMP access settings numbered 1-
10.
❒ If you change the community
name, you must change your com-
puter settings. See p.116 "SNMP".
❒ Default access settings 1 and 2 are
as follows:
Number 1
Community public
name
IP address 0.0.0.0
Access type read-only
trap off
9
2
admin
0.0.0.0
read-write
trap off
101