Polling Transmission Clear Report - Ricoh Aficio 1022 Operating Instructions Manual

B B B B Specify a 4 digit ID Code with
the number keys and the [A],
[B], [C], [D], [E] and [F] keys.
Note
❒ If you make a mistake, press
the { { { { Clear/Stop} } } } key or [Clear]
and try again.
E E E E
Press [Only Once] or [Save] to delete
or save the file after transmission.
Note
❒ To delete the message immedi-
ately after transmission, select
[Only Once].
❒ To repeatedly send the mes-
sage, select [Save].
❒ To cancel this procedure, press
[Cancel]. The display will return
t o t h e T ra n s m i ss io n M o d e
menu.
F F F F
Press [OK].
The Transmission Mode menu is
shown. The [Polling TX] key is high-
lighted, and the specified mode is
shown.
G G G G
Press [OK].
The initial display is shown.
H H H H
Press the { { { { Start} } } } key.
Polling Transmission Clear
Report
This report allows you to verify
whether Polling Transmission has
taken place.
Limitation
❒ This report is not printed if the User
Parameters are set to allow the
stored documents to be repeatedly
sent (Save). ⇒ p.141 "Changing the
User Parameters"(Switch11, Bit7)
Note
❒ You can choose whether this re-
port is printed.⇒ p.141 "Changing
the User Parameters"(Switch03,
Bit6)
❒ You can also check the result of
Polling Transmission in ⇒ p.25
"Printing the Journal"
❒ You can choose whether a portion
of the sent image is printed on the
report. Set this with the User Pa-
rameters. ⇒ p.141 "Changing the
User Parameters"(Switch04, Bit7)
❒ You can set whether a Polling
Transmission file is deleted after
being transmitted in "User Param-
eters". If you want to save the file
to transmit repeatedly, select
"Standby (Save)".⇒ p.141 "Chang-
ing the User Parameters"(Switch
11, Bit7)
Polling Transmission
11
1