Proof Copy - Kyocera KM-C2525E Advanced Operation Manual

Proof Copy

Make a test copy of a single set to verify settings before printing the remaining sets. If a problem is
found, avoid wasting paper canceling the remaining copy job.
Follow the steps below to do a Proof copy job.
1 Press [Function] and then press [
2 Press [Proof Copy] ([Test Copy]).
3 Press [On].
4 Place the original and press the Start key. The proof copy begins.
5 After printing a single test copy, a
confirmation screen will be displayed,
and the copier will remain in standby
mode until the job is approved or
cancelled. Check the proof copy.
If it is acceptable, press the Start key.
The remaining sets will be printed.
To change the copy quantity, press
[Change Preset] and change the copy
count.
If there is a problem with the copy, press [Cancel] to redo the copy settings.
Down].
Ready to Proof Copy.
Proof Copy
Off
On
Check proof copy.
To stop and retry, press "Cancel" key.
To continue to print, press "Start" key.
Orig. Page
11×8½"
1 sided APS
Top Edge
Job
Copy Functions
( Full-Color ) Paper Size
Shortcut Back
Proof copy outputs one set for proo
Count/Set Output
11×8½" Plain
Color, 1 side
Top tray
Change
Preset
11×8
100%
1-35