Kyocera KM-C2525E Advanced Operation Manual page 238

Included Scanner Utilities
Item
2 sided
Status Field
Brightness
Scan/Connect(s) Button
Waiting Scan Checkbox
Preview
Default Button
Scan. Setup Button
Close Button
Help Button
Change Scanner IP Address
If the Scanner IP address has changed after TWAIN Source was installed, change the IP address to
use when connecting to the scanner. Follow the steps below to perform the operation.
1 Click the Scan. Setup button on the TWAIN Source main dialog box. The Scanner Setup dialog
box is shown.
2
The currently configured address is shown in the Scanner
Address field. Click the Edit button to change this address.
The Address Setting dialog box is shown.
3 Enter the new IP address.
4 Click the OK button. The screen returns to the Scanner Setup dialog box.
5 Click the OK button. The scanner's IP address is changed.
6-46
Description
Sets whether to scan both sides of an original with the optional
document processor.
None: Scan only 1 side of the original.
2 sided (Left/Right): Set to scan left/right binding 2-sided originals.
2 sided (Top): Set to scan top-binding 2-sided originals.
The device status is displayed.
Specify the image exposure.
When successfully connected, this button turns into the Scan button.
Click this button to begin scanning. When not connected, this button
becomes the Connect(s) button. Click to reconnect to the scanner.
For high resolution scanning, during image processing, the
connection to the scanner may be lost.
When checked, the scanner stops remaining in scanner mode. In this
mode, to begin scanning originals requires the Start key on the
scanner operation panel to be pressed.
When checked, the image can be confirmed or colors adjusted
before importing into the computer.
Resets all TWAIN Source settings to defaults when clicked.
Click this button to display the Scanner Setup dialog box. From this
dialog box, change the scanner address (see Change Scanner IP
Address), units (inches, centimeters), or set whether to compress
data when scanning.
Cancels settings and closes the main dialog box.
Click this button to show the Help screen.