Kyocera KM-C2525E Advanced Operation Manual page 100

Printer Settings
Serial Interface Mode Configuration
An optional serial interface can be installed. Configure the baud rate (communication speed), data
big, stop bit, parity, and protocol to be used by the serial interface. These protocol settings must
match the settings of the computer serial interface.
Setting Item
Baud rate
Data bit
Stop bit
Parity
Protocol
1 Press the Printer key.
2 Press [Printer Menu].
3 Press [Interface].
4 Press [Serial].
5 Press [ ] or [ ] to select Baud Rate and press [Change #].
6 Select the desired mode.
7
Press [Close]. The display returns to the Serial screen.
8 Refer to steps 5 - 7 to configure data bit, stop bit, parity and protocol.
9 Press [Close]. The display is returned to the Printer menu screen.
Network Interface Setting
This device includes a network interface as standard equipment which supports TCP/IP, IPX/SPX,
NetBEUI and AppleTalk protocols to enable network printing for Windows, Macintosh, UNIX,
Netware and other environments.
NOTE: Follow the same steps to set the optional network interface as well as the standard network
interface.
TCP/IP Settings
To connect to a Windows network via TCP/IP, set to [On]. Continue to set DHCP, BOOTP, IP
address, subnet mask address, and gateway address.
NOTE: Before setting the IP address, check with your network administrator for an IP address in
advance. For environments that use DHCP or BOOTP to automatically assign the IP address, this
setting is not required because the DHCP and BOOTP are set to [On] by default.
3-6
Selection Item
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
7, 8
1, 2
None, Odd, Even, Ignore
DTR (positive) &XOn/XOff, DTR (positive), DTR (negative),
XOn/XOff, ETX/ACK
Select item.
Printer menu
Print Sta-
Font
tus Page
Interface Page Set
Print
Emulation
Quality
Paper
Others
Handling
Color Mode
RAM DISK
Mode