Kyocera KM-C2525E Advanced Operation Manual page 336

Troubleshooting
Display
Exceeded print quantity limit.
Error has occurred. Change to
printer screen and check.
RAM disk error Press GO.
Code: ##
Memory Card error Press GO.
Code: ##
HARD DISK error Press GO.
Code: ##
KPDL error Press GO.
Memory card error Insert again. Was the memory card
Insert the same Memory card.
Format error Memory card.
Option interface error
Code: ##
File not found Press GO.
Read Fonts: Failed
Read macro: Failed
Warning Low memory.
9-12
Checkpoints
Is the maximum limit for printing as
specified in Job Accounting mode
exceeded?
—
—
—
—
—
(CompactFlash) removed during
printer configuration?
—
—
Is the installed option interface slot
incorrect?
—
—
—
—
Corrective Actions
To perform printing, reconfigure Job
Accounting for the machine.
Shown when a printer error has
occurred when other modes are
currently being displayed. Press the
Printer key to switch to the printer
screen and display the specific error
message.
(For further details, refer to RAM
Disk Error on page 9-14.)
(For further details, refer to Memory
Card Errors on page 9-14.)
(For further details, refer to Hard
Disk Errors on page 9-14.)
Unable to continue processing
current print job. From the printer
menu, open KPDL Error Print and
select [On] to print an error report.
Press [GO] to print data up to the
point of error. If resume time has
been configured for Auto Continue,
printing resumes automatically after
the set time has elapsed.
Insert the memory card. When
inserting the memory card, turn off
the main power switch.
Memory card (CompactFlash) could
not be recognized when reading
data from the memory card.
Re-insert the memory card. When
inserting the memory card, turn off
the main power switch.
The inserted memory card
(CompactFlash) requires formatting.
Format the memory card.
Switch the main power switch to off
( position) and install in the correct
slot.
A file error has occurred. Press
[GO].
Unable to read font data. Try the font
data read operation again.
Unable to read macro data. Try the
macro data read operation again.
Memory is low. Print the status page
to confirm the current printer
memory capacity. Delete
unnecessary font or macro data.
Reference
Page
page 8-4
—
page 9-14
page 9-14
page 9-14
page 3-11
page 3-27
page 3-27
page 3-27
—
—
page 3-29
page 3-29
—