Example 2 - Intermec EasyCoder PL3 Programmer's Reference Manual

Chapter 12— LCD Programming for PL-Series

Example 2:

114
PL4
Status Batter:7.80V (ok)
Latch:ok Paper:ok
IP:10.14.4.97
TCP Port:6101
ESSID: Yournet
Associated:yes
Note: The LCD screen is 20 characters across and 4 lines.
This example is not a complete menu setup. It is a sample card. It is meant
as a tool to break down the tags and explain their use.
Comments
<!— *************************************** —>
<!— ******** Setup Comm Baud Card ********* —>
<!— *************************************** —>
Begin card, the card name is baud, the title is
"Com,Baud", when the 20 second timer expires go to the
card called status.
<card id="baud" title="Com,Baud" ontimer="#status">
<timer value="200"></timer>
Display the current baud rate after four spaces.
<p> $(vnd.zo.comm.baud)</p>
Do a line break
</br>
Display 9600 and put three spaces after it, if 9600 is
selected then execute the setvar command to change the
baud rate to 9600 in the <do> ... </do> and refresh the
display.
<do type="accept" label="9600">
<setvar name="vnd.zo.comm.baud" value="9600"/><refresh/>
</do><p> </p>
Display 19200, if 19200 is selected then execute the
setvar command to change the baud rate to 19200 in the
<do> ... </do> and refresh the display.
<do type="accept" label="19200">
<setvar name="vnd.zo.comm.baud" value="19200"/><refresh/>
</do>
Do a line break
</br>
Link the card back to the previous menu.
<p><a href="#comm">Back</a> </p>
Link the card back to the main menu.
EasyCoder PL-Series Printer Programmer's Reference Manual
more
back