Intermec PM43 Installation Instructions Manual
Hide thumbs
Also See for PM43:
- User manual (152 pages) ,
- Service manual (70 pages) ,
- Quick start manual (7 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Intermec PM43
Summary of Contents for Intermec PM43
- Page 1 PM 43 Full Roll Rewinder Installation Instructions...
- Page 2 Intermec Technologies Corporation. Information and specifications contained in this document are subject to change without prior notice and do not represent a commitment on the part of Intermec Technologies Corporation. © 2012 by Intermec Technologies Corporation. All rights reserved.
- Page 3 The full roll rewinder must only be installed by an authorized service technician. Follow standard ESD guidelines to avoid damaging the equipment you are servicing. Before you begin, turn off the printer and disconnect the power cord and communication cables. PM43 Full Roll Rewinder Installation Instructions...
- Page 4 2 Use the small wrench to loosen the nut that secures the media cover latches in place. 3 Slide the latches counterclockwise into the open position. 4 Lower the media cover and lift it off the hinges. PM43 Full Roll Rewinder Installation Instructions...
- Page 5 2 Use a T20 Torx screwdriver to remove the two screws located on the outside of the electronics cover. 3 Remove the electronics cover, and put the cover aside on a soft cloth to avoid scratches. PM43 Full Roll Rewinder Installation Instructions...
- Page 6 1 Open the media access door and pull up on the ends of the door until it snaps off of the printer base. 2 Remove the three screws that connect the tear bar to the printer and remove it. (x3) PM43 Full Roll Rewinder Installation Instructions...
- Page 7 3 Remove the five screws that attach the printer spine to the base. Remove One Screw from the Media Side of Base (x2) (x2) Remove Four Screws from the Electronics Side of Base 4 Lift the spine away from the printer base. PM43 Full Roll Rewinder Installation Instructions...
- Page 8 5 Attach the spine to the full roll rewinder with the five screws removed in Step 3. Attach the Spine with One Screw on the Media Side (x2) (x2) Attach the Spine with Four Screws on the Electronics Side PM43 Full Roll Rewinder Installation Instructions...
- Page 9 7 Feed the full roll rewinder cable through the cable clip and then insert it into the RWNDR connector on the main logic board. 8 Replace the electronics cover. PM43 Full Roll Rewinder Installation Instructions...
- Page 10 9 Attach the batch plate with the three screws you removed from the tear bar in Step 2. (x3) 10 Replace the media cover. 11 Open the full roll rewinder door and move the media roll guide out to the edge of the base. PM43 Full Roll Rewinder Installation Instructions...
- Page 11 12 Raise the media roll guide to the upright position and insert the cardboard core onto the media roll rewinder hub. 13 Close the full roll rewinder door. 14 Close the media cover. PM43 Full Roll Rewinder Installation Instructions...
- Page 12 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2012 Intermec Technologies Corporation. All rights reserved. PM43 Full Roll Rewinder Installation Instructions *931-098-001* P/N 931-098-001...