Bluetooth Parameters
EasyCoder PL-Series Printer Programmer's Reference Manual
appl.name
Type: getvar
This parameter refers to the printer's application name.
getvar result
Returns the printer's application name.
Example
Description
Syntax
Result
appl.version
Type: getvar
This parameter refers to the printer's application version.
getvar result
Returns the printer application version as a 4-digit (hex) number.
Example
Description
Syntax
Result
™
Bluetooth
parameter names are only available with Bluetooth enabled
applications. Changes made to Bluetooth parameters with the setvar
command are set in the printer but do not take effect until a new link is
established, power is turned off and on, or you issue the device.reset
command. Changes do not affect an existing communications link and do
not cause a disconnect.
Note: Bluetooth encryption is set by the master device in a Bluetooth
network. Since printers are always slave devices, there are no encryption
parameters discussed.
bluetooth.address
Type: getvar
This parameter is the Bluetooth device address programmed into each
radio.
getvar result
Returns the printer's Bluetooth address.
Example
Description
Syntax
Result
Chapter 13— Configuration/Control Commands
Get printer application name.
! U1 getvar "appl.name"
"htstd40a.hex
"
Get printer application's version.
! U1 getvar "appl.version"
"7940"
Get printer's Bluetooth address.
! U1 getvar "bluetooth.address"
"00:80:37:16:87:71"
121