Table of Contents
Advertisement
Justification Commands
Purpose: You can control alignment of fields by using the Justification commands.
Format:
Example Input:
Example Output:
Page-Width Command
Purpose: The printer assumes that the page width is the full width of the printer.
EasyCoder PL-Series Printer Programmer's Reference Manual
By default, the printer left justifies all fields. A Justification command
remains in effect for all subsequent fields until you specify another
justification command.
{command} [end]
where:
{command}: Choose from the following:
CENTER
LEFT
RIGHT
[end]:
End point of justification. If no parameter is entered,
justification commands use the print head's width for
horizontal printing or zero (top of form) for vertical printing.
Input (JUSTIFY.LBL):
! 0 200 200 210 1
CENTER 383
TEXT 4 0 0 75 C
LEFT
TEXT 4 0 0 75 L
RIGHT 383
TEXT 4 0 0 75 R
FORM
PRINT
The maximum height of a print session is determined by the page width
and the available print memory. If the page width is less than the full
width of the printer, you can increase the maximum page height by
specifying the page width.
Note: You should issue this command at the beginning of a print session.
Chapter 8— Advanced Commands
Center justifies all subsequent fields.
Left justifies all subsequent fields.
Right justifies all subsequent fields.
69
Advertisement
Table of Contents
