Wlan.power_Save; Wlan.preamble - Intermec EasyCoder PL3 Programmer's Reference Manual

EasyCoder PL-Series Printer Programmer's Reference Manual
getvar result Returns the current Network Operating mode.
Example Description
Syntax
Result
setvar choices ad hoc, infrastructure. Default = infrastructure
Example Description
Syntax
Result

wlan.power_save

Type: getvar ; setvar
This parameter refers to the Power Save modes that affect power
consumption of the network radio card in the printer. Two radio cards are
currently supported: Compact Flash and PCMCIA card. The Compact
Flash radio has a range of Power Save modes from 1 (best throughput) to
best (best power save). The PCMCIA card radio has a fast Power Save
mode and a full Power Save mode (best). Any setting (1 to 4) switches
between Power Save and off and is not scalable. The off setting puts either
radio into CAM (Constant Awake mode).
getvar result Returns the current Power Save mode setting.
Example Description
Syntax
Result
setvar choices off, 1, 2, 3, 4, best. Default = best
Example Description
Syntax
Result

wlan.preamble

Type: getvar; setvar
This parameter selects the radio preamble length to be used.
Chapter 13— Configuration/Control Commands
Get the value of the Network Operating mode.
! U1 getvar "wlan.operating_mode"
"infrastructure"
Set the Network Operating mode to infrastructure.
! U1 setvar "wlan.operating_mode"
"infrastructure"
Sets the printer's Network Operating mode to
infrastructure.
Get the value of the wlan.power_save mode.
! U1 getvar "wlan.power_save"
"off"
Set the value of the Power Save mode.
! U1 setvar "wlan.power_save" "2"
Changes the Power Save mode to 2 if a Compact Flash
radio is used or Fast Power Save mode if a PCMCIA
card radio is used.
157