Auto-Pace Command - Intermec EasyCoder PL3 Programmer's Reference Manual

Format:
Example: In the following example, the command file shown was sent to the printer

Auto-Pace Command

Purpose: You can use this command to instruct a printer equipped with a label
Format:
EasyCoder PL-Series Printer Programmer's Reference Manual
{command}
where:
{command}: PACE
once. The two additional printouts were produced by pressing the Feed
button once for each additional printout.
Input (PACE.LBL):
! 0 200 200 210 3
; Tell printer to print a label
; after each 'FEED' key press
; until all 3 labels are printed
PACE
; Printer holds journal stock
JOURNAL
; Center the text
CENTER
TEXT 4 1 0 10 Print 3 labels
TEXT 4 1 0 90 Using PACE
PRINT
Output:
presentation sensor to delay printing until the previously printed label is
removed.
{command}
Chapter 8— Advanced Commands
71