Example
Command
D8
j110
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
Let us assume that we will use an EasyCoder C4 for direct thermal
printing. We will print full width Thermal Top labels in the
peel-off mode without using the label taken sensor. The default
communication setup and character set are acceptable.
Thus, a few setup parameters should be changed in the Direct
Mode:
• Density from 10 to 8
• Media feed adjustment from 136 to 110
Enter the following commands:
Explanation
CR/LF to start command structure
Set density
Set media feed adjustment for peel-off operation
Chapter 3
Setting Up the Printer
13