Wlan.leap_Mode; Wlan.leap_Password - Intermec EasyCoder PL3 Programmer's Reference Manual

EasyCoder PL-Series Printer Programmer's Reference Manual
getvar result Returns the Kerberos user name.
Example Description
Syntax
Result
setvar choices 0 to 32 ASCII characters. Default = user
Example Description
Syntax
Result

wlan.leap_mode

Type: getvar; setvar
Note: The Trakker Antares family of terminals will support LEAP. Check
with your Intermec sales representative for availability.
This parameter refers to Cisco LEAP (Lightweight Extensible
Authentication Protocol). LEAP provides secure mutual authentication for
a wireless client through a Cisco Aironet access point, based on user
information stored on the backend RADIUS (Remote Authentication in
Dial-Up User Service) /AAA (Authentication, Authorization, and
Accounting) server.
getvar result Returns the LEAP mode.
Example Description
Syntax
Result
setvar choices on, off. Default = off
Example Description
Syntax
Result

wlan.leap_password

Type: getvar; setvar
This parameter refers to the LEAP password. The password must
correspond to a user profile established on the RADIUS/AAA server in
use.
Chapter 13— Configuration/Control Commands
Get the Kerberos user name.
! U1 getvar "wlan.kerberos.username"
"user"
Set the Kerberos user name to user.
! U1 setvar "wlan.kerberos.username"
"user"
Sets the Kerberos user name to user.
Get the LEAP mode.
! U1 getvar "wlan.leap_mode"
"off"
Turn on LEAP mode.
! U1 setvar "wlan.leap_mode" "on"
Sets the LEAP mode to on.
155