Tools Required; Exploded View Diagram; Figure 4-1. Exploded View Diagram Of The B2000 Workstation Frus - HP Vizualize,Visualize b2000 Supplementary Manual

Tools Required

Use the following tools to remove or replace FRUs in the B2000 workstation:
• Torx T-15 driver
• Light-duty flat blade screw driver with 6-inch (150 mm) blade
• Needle-nose pliers
• ESD equipment (see "Electrostatic Discharge (ESD) Precautions" on page 177)

Exploded View Diagram

Figure 4-1 shows an exploded view of the FRUs in the B2000 workstation. Refer to this
figure for the locations of the various workstation FRUs while performing the FRU
removal and replacement procedures in this chapter.

Figure 4-1. Exploded View Diagram of the B2000 Workstation FRUs

I/O Fan
in Bracket
PCI
Retainer
Clip
System Fan
DIMM
Cards
Battery
Left Side
Panel
Power
Supply
Chapter 4
Air Divider
Speaker
Voltage
Regulator
Modules
System Board
(Master
Tray Assembly
and Slave)
Field Replaceable Units
Chapter Overview
Chassis
CD Drive
Bracket
Floppy Disk
Drive Bracket
Hard Disk Drive
and Bracket
Front Panel
83