Power Supply
This section explains how to remove and replace the power supply in the B2000
workstation.
Removing the Power Supply
WARNING
To prevent injury, unplug the workstation's power cord from the
electrical outlet before removing the power supply.
Perform the following steps to remove the power supply:
1. Open the left side panel of the workstation as shown in the section "Opening the Left
Side Panel."
2. Unplug the three power supply cables from the system board.
3. Remove the rear cover of the CD drive bay and disconnect the power cable. To do this,
see the section "Removing and Replacing a CD Drive" on page 91.
4. Remove the rear cover of the floppy disk drive bay and disconnect the power cable, if the
optional floppy disk drive is installed. To do this, see the section "Removing a Floppy
Disk Drive" on page 96.
5. Detach the bundled power cables from the cable management clips on the chassis floor.
See Figure 4-46.
Figure 4-46. Screws Holding the Power Supply in Place
Four T-15
Torx Screws
6. Remove the four T-15 Torx screws from the rear of the chassis that hold the power
supply in place, as shown in Figure 4-46.
7. Slide the power supply towards the front of the workstation. You must disengage the
hook on the bottom of the power supply from the support strap in the chassis floor. Then
remove the power supply from the workstation chassis.
Chapter 4
Cable Management Clips
Power Supply
Field Replaceable Units
FRU Removal and Replacement
119