Field Replaceable Units
FRU Removal and Replacement
Memory DIMMs
This section explains how to remove and replace (or install additional) memory DIMM
cards in the B2000 workstation.
Removing Memory DIMMs
WARNING
Always unplug the workstation's power cord from the electrical
outlet or power source before opening the workstation.
Perform the following steps to remove memory DIMMs:
1. Open the left side panel of the workstation as shown in the section "Opening the Left
Side Panel."
Figure 4-39. System Board View
Power
Supply
Figure 4-40. DIMM Connectors on the System Board
DIMM
Connectors
(4 Slots)
114
DIMM Connectors
B2000
System Label
Chapter 4