HP Vizualize,Visualize b2000 Supplementary Manual page 69

Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU
INI 91DB IO BD
INI 9C51 IO BD
WRN 9C51 IO BD
INI 9C52 IO BD
WRN 9C52 IO BD
INI 9C6s EXT IO
WRN 9C6s EXT IO
INI 9C8t EXT IO
WRN 9C8t EXT IO
INI 9CDB IO BD
WRN 9CDB IO BD
FLT A088 IO BD
WRN A008 EXT IO
WRN A0BD EXT IO
FLT A0FF EXT IO
WRN A50F EXT IO
WRN A70F EXT IO
INI C10m SYS BD
INI C30m SYS BD
INI C30C SYS BD
Chapter 3
Message
init SERIAL_LDB
consol is SER_1
bad init SERIAL1
consol is SER_2
bad init SERIAL2
consol is GRAPH s
bad PCI slot s
cnfg mon type t
mon type t fail
consl is SER_LDB
bad init SER_LDB
consl path fault
no boot device
device not ready
unknown launch
init pri pth err
init otr pth err
CPU m is monarch
monarch m test
mnrch slv chck
Description
Initializing serial LDB port as console
display.
Console display is on serial port 1.
Serial port 1 failed to initialize as a
console device.
Console display is on serial port 2.
Serial port 2 failed to initialize as a
console device.
Console display is on graphics card in PCI
slot s.
Graphics in PCI slot s failed to initialize
as a console device.
Set graphics console to monitor type t.
(Seen when cycling through types.)
Failed to configure console to monitor type
t.
Console display is on serial LDB port.
Serial LDB port failed to initialize as a
console device.
Unable to boot--no console device found.
Unable to boot--no bootable device found.
Boot device not ready--operation may be
retried.
Unable to boot. Explanation may appear
on console.
Unable to boot from primary boot device.
Unable to boot from non-primary boot
device.
CPU m was chosen as the monarch
processor. (All other CPUs are slaves.)
CPU m finished the monarch-only tests
and system initialization.
The monarch CPU is checking whether
the slaves are in the correct rendezvous.
Troubleshooting
Selftest Failures
69