HP Vizualize,Visualize b2000 Supplementary Manual page 71

Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU
TST C680 SYS BD
INI C680 SYS BD
WRN C680 SYS BD
TST C68s SYS BD
INI C68s SYS BD
WRN C68s SYS BD
INI C740 EXT IO
INI C780 EXT IO
WRN C7F0 EXT IO
WRN C7F1 EXT IO
WRN C7F2 EXT IO
WRN C7F3 EXT IO
WRN C7F4 EXT IO
WRN C7F8 EXT IO
<blank>
WRN C7FF
INI CB00 SYS BD
WRN CB01 SYS BD
WRN CB02 SYS BD
Chapter 3
Message
builtin graphics
builtin graphics
builtin graphics
test graph in s
init graph in s
fail graph in s
init other path
ld IPL othr path
other IPL fault
bad alt IPL read
bad alt IPL read
bad alt IPL read
bad alt IPL read
bad alt IPL read
launch IPL other
TOC initiated
no OS TOC vector
bad OS TOC addr
Description
Look for built-in graphics card.
Successfully initialized built-in graphics
card.
Built-in graphics initialization failed.
Look for graphics card in PCI slot s.
Successfully initialized graphics card in
PCI slot s.
Card in PCI slot s failed graphics
initialization or is not a graphics card.
Autoboot is trying to boot from
non-primary boot device.
Loading IPL from non-primary boot
device.
Error loading IPL from non-primary boot
device.
Cannot load IPL from non-primary boot
device--load address invalid.
Cannot load IPL from non-primary boot
device--file is not IPL image.
Cannot load IPL from non-primary boot
device--IPL image size invalid.
Cannot load IPL from non-primary boot
device--IPL entry point address invalid.
Cannot load IPL from non-primary boot
device--IPL image checksum failed.
Booting from a device other than the
primary boot path.
A Transfer of Control entered the
firmware TOC handler.
There is no TOC vector for the operating
system. Firmware will soft boot the
system.
The operating system TOC handler vector
is invalid. Firmware will soft boot the
system.
Troubleshooting
Selftest Failures
71