To set a system path to a new value, follow the directions in "Accessing the Boot Console
Handler" earlier in this chapter, and then type the following at the prompt and press
Main Menu: Enter command> path path_type path
where path_type is one of the path types listed in Table 6-1 and path is the specification of
the path in Mnemonic Style Notation (as described in Table 6-2). For example, to set the
primary boot path to a SCSI disk with ID of 6.0, follow the directions in "Accessing the
Boot Console Handler" earlier in this chapter, and then type the following at the prompt
and press
:
Enter
Main Menu: Enter command> path pri scsi.6.0
NOTE
The default B2000 paths are:
pri scsi.6.0
alt scsi.5.0
Chapter 6
Boot Console Handler
Displaying and Setting Paths
Enter
149
:
Need help?
Do you have a question about the Vizualize,Visualize b2000 and is the answer not in the manual?