Setting The Monitor Type With Sam - HP Vizualize,Visualize b2000 Supplementary Manual

Boot Console Handler
Displaying and Setting the Monitor Type
To set the monitor type for GRAPHICS(2) to monitor type 1, type the following at the
command prompt and press
Configuration Menu: Enter command> monitor graphics(2) 1
This will take effect on the next reboot or reset of the system.
MONITOR INFORMATION
Path Slot Head
---------- --- --- -------
GRAPHICS(0) 0
Configuration Menu: Enter command>
The Boot Console Handler displays a message that tells you that the new monitor selection
will take effect the next time you reboot the system. The Boot Console Handler also
displays the new monitor information.
Trying to change the monitor type to a number not listed for that graphics device fails and
gives you the following warning message:
Value of monitor type n out of range ( n - nn )
Trying to change the monitor type on an empty slot fails and gives you the following
warning message:
No such graphics card.

Setting the Monitor Type with SAM

The System Administration Manager (SAM) allows you to change the monitor type after
the HP-UX 10.20 operating system with the 9912 Additional Core Enhancements (ACE)
software bundle (December 1999) have been installed on the workstation. This section
provides a brief explanation on how to set the monitor type using SAM. Note that you will
need to be logged in as root to run SAM.
Here are the steps for setting the monitor type with SAM:
1. Log in as root.
2. Move the mouse pointer to the Application Manager control for tools and click the left
mouse button. Alternatively you can execute sam at a terminal window command
prompt and skip to step 5.
152
:
Enter
HPA Resolution Freq Type Class
---------- ----
1 fffa000000 1280x1024 75Hz
--- ---
1 VESA
Chapter 6