Figure 4-20. Removing The Floppy Disk Drive Bracket And Blank - HP Vizualize,Visualize b2000 Supplementary Manual

4. Remove both floppy disk drive bracket screws (T-15 Torx/slotted screws) and pull the
floppy disk drive bracket out of the workstation chassis as shown in Figure 4-20.

Figure 4-20. Removing the Floppy Disk Drive Bracket and Blank

Floppy Disk Drive
Mounting Screws
(T-15 Torx)
5. Remove the four floppy disk drive mounting screws (T-15 Torx/slotted screws) from the
sides of the floppy disk drive bracket as shown in Figure 4-20 and remove the floppy
disk drive blank from the bracket.
6. Remove the new floppy disk drive from its shipping container. Using the four T-15
Torx/ slotted mounting screws, mount the floppy disk drive to the bracket as shown in
Figure 4-21.
To help you properly install the floppy disk drive, you need to use the floppy disk drive
holes labeled "A" on the bracket sides. The first T-15 Torx screws should be inserted
through the tab holes of the floppy disk drive bracket that are located on the front part
of both sides of the bracket. These T-15 Torx screws should then be screwed into the
screw holes located on both sides of the floppy disk drive. These holes are located near
the floppy disk drive's front panel. The remaining T-15 Torx screws should be inserted
through the holes labeled "A" at the rear part of the floppy disk drive bracket. These
screws should then be screwed into the rear screw holes located on both sides of the
floppy disk drive. Note that the front of the floppy disk drive should extend one inch
from the front of the floppy disk drive bracket. See Figure 4-21.
Chapter 4
Floppy Disk
Drive Bracket
Bracket Screw
Field Replaceable Units
FRU Removal and Replacement
Floppy Disk Drive
Mounting Screws
(T-15 Torx)
Bracket
Screw
Floppy Disk
Drive Blank
101