Eis Display In Reversionary Mode - Garmin G1000:Beechcraft Baron 58/G58 User Manual

ENGINE INDICATION SYSTEM

3.2 EIS DISPLAY IN REVERSIONARY MODE

In the event of PFD1, PFD2 or MFD failure, the Display Backup button must be pressed to enter reversionary
(or backup) mode. Reversionary mode is a mode of operation in which all important flight information is
presented identically on at least one of the remaining displays (see Figure 3-12). Transition to reversionary
mode should be straightforward for the pilot, for flight parameters are presented in the same format as in
normal mode (refer to the System Overview for information about display Reversionary Mode).
EIS Display
In the event of display failure, the display modes are as follows:
• PFD1 failure – Press the Display Backup button on the left Audio Panel. MFD enters reversionary mode; PFD2
remains in normal mode.
• MFD failure – Press the Display Backup buttons on both Audio Panels. PFD1 and PFD2 enter reversionary
mode.
• PFD2 failure – Press the Display Backup button on the right Audio Panel. MFD enters reversionary mode;
PFD1 remains in normal mode.
3-8
Figure 3-12 Reversionary Mode (C90A/GT)
Figure 3-13 Display Backup Button
Garmin G1000 Pilot's Guide for the Hawker Beechcraft C90A/GT 190-00663-00 Rev. A