Garmin G1000:Beechcraft Baron 58/G58 User Manual page 134

AUDIO PANEL AND CNS
GROUND MODE
Ground Mode is normally selected automatically when the aircraft is on the ground. The transponder
powers up in the last mode it was in when shut down. Ground Mode can be overridden by selecting any one
of the Mode Selection Softkeys. A green GND indication and transponder code appear in the mode field of
the Transponder Data Box. In Ground Mode, the transponder does not allow Mode A and Mode C replies,
but it does permit acquisition squitter and replies to discretely addressed Mode S interrogations.
When Standby Mode has been selected on the ground, the transponder can be returned to Ground Mode
by selecting the GND Softkey.
STANDBY MODE (MANUAL)
In Standby Mode, the IDENT function is inhibited.
NOTE:
Standby Mode can be selected at any time by selecting the STBY Softkey. In Standby, the transponder does
not reply to interrogations, but new codes can be entered. When Standby is selected, a white STBY indication
and transponder code appear in the mode field of the Transponder Data Box. In all other modes, these fields
appear in green.
MANUAL ON MODE
ON Mode can be selected at any time by selecting the ON Softkey. ON Mode generates Mode A and Mode S
replies, but Mode C altitude reporting is inhibited. In ON Mode, a green ON indication and transponder
code appear in the mode field of the Transponder Data Box.
4-28
Figure 4-31 Ground Mode
Figure 4-32 Standby Mode
Figure 4-33 ON Mode
Garmin G1000 Pilot's Guide for the Beechcraft C90A/GT
GND
Mode
STBY Mode (White
Code Number and
Mode)
ON Mode
(No Altitude
Reporting)
190-00663-00 Rev. A