Nav Operation; Nav Radio Selection And Activation - Garmin G1000:Beechcraft Baron 58/G58 User Manual

AUDIO PANEL AND CNS

4.3 NAV OPERATION

NAV RADIO SELECTION AND ACTIVATION

The NAV Frequency Box is composed of four fields; two standby fields and two active fields. The active
frequencies are on the right side and the standby frequencies are on the left.
A NAV radio is selected for navigation by selecting the CDI Softkey located on the PFD. The active NAV
frequency selected for navigation is displayed in green. Selecting the CDI Softkey once selects NAV1 as the
navigation radio. Selecting the CDI Softkey twice selects NAV2 as the navigation radio. Selecting the CDI
Softkey a third time activates GPS mode. Selecting the CDI Softkey again cycles back to NAV1.
While cycling through the CDI Softkey selections, the NAV Tuning Box and the Frequency Transfer Arrow are
placed in the active NAV Frequency Field and the active NAV frequency color changes to green.
The three navigation modes that can be cycled through are:
• VOR1 (or LOC1) – If NAV1 is selected, a green single line arrow (not shown) labeled either VOR1 or LOC1
is displayed on the HSI and the active NAV1 frequency is displayed in green.
• VOR2 (or LOC2) – If NAV2 is selected, a green double line arrow (shown) labeled either VOR2 or LOC2 is
displayed on the HSI and the active NAV2 frequency is displayed in green.
• GPS – If GPS Mode is selected, a magenta single line arrow (not shown) appears on the HSI and neither NAV
radio is selected. Both active NAV frequencies are then displayed in white.
Tuning Box
See the Flight Instruments Section for selecting the DME and Bearing Information windows and using VOR
or ADF as the source for the bearing pointer.
4-16
Standby Active
Fields Fields
The NAV Radio is
Selected by Selecting
the CDI Softkey
Figure 4-17 Selecting a NAV Radio for Navigation
Garmin G1000 Pilot's Guide for the Beechcraft C90A/GT 190-00663-00 Rev. A