Garmin G1000:Beechcraft Baron 58/G58 User Manual page 20

SYSTEM OVERVIEW
The following list provides an overview of the controls located on the PFD bezel (see Figure 1-2).
NAV VOL/ID Knob – Controls NAV audio volume level. Press to toggle the Morse code identifier audio ON
1
and OFF. Volume level is shown in the NAV frequency field as a percentage.
NAV Frequency Transfer Key – Toggles the standby and active NAV frequencies.
2
Dual NAV Knob – Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for
3
kHz). Press to switch the tuning box (cyan box) between NAV1 and NAV2.
Joystick – Changes the map range when rotated. Activates the map pointer when pressed.
4
BARO Knob – Sets the altimeter barometric pressure. Press to enter standard pressure (29.92).
5
Dual COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small
6
knob for kHz). Press to switch the tuning box (cyan box) between COM1 and COM2.
COM Frequency Transfer Key – Toggles the standby and active COM frequencies. Press and hold this
7
key for two seconds to tune the emergency frequency (121.5 MHz) automatically into the active frequency
field.
COM VOL/SQ Knob – Controls COM audio volume level. Volume level is shown in the COM frequency
8
field as a percentage. Press to turn the COM automatic squelch ON and OFF.
Direct-to Key (
9
selected destination (the destination is either specified by the identifier, chosen from the active route, or
taken from the map pointer position).
FPL Key – Displays the active Flight Plan Page for creating and editing the active flight plan.
10
CLR Key – Erases information, cancels entries, or removes page menus.
11
Dual FMS Knob – Flight Management System Knob. Press the FMS Knob to turn the selection cursor
12
ON and OFF. When the cursor is ON, data may be entered in the applicable window by turning the small
and large knobs. The large knob moves the cursor on the page, while the small knob selects individual
characters for the highlighted cursor location.
MENU Key – Displays a context-sensitive list of options. This list allows the user to access additional
13
features or make setting changes that relate to particular pages.
PROC Key – Gives access to IFR departure procedures (DPs), arrival procedures (STARs) and approach
14
procedures (IAPs) for a flight plan. If a flight plan is used, available procedures for the departure and/or
arrival airport are automatically suggested. These procedures can then be loaded into the active flight plan.
If a flight plan is not used, both the desired airport and the desired procedure may be selected.
ENT Key – Validates or confirms a menu selection or data entry.
15
1-8
) – Allows the user to enter a destination waypoint and establish a direct course to the
Garmin G1000 Pilot's Guide for the Hawker Beechcraft C90A/GT 190-00663-00 Rev. A